AquataPoxy A-6 and A-6 Thick are solvent-free, 100%
solids, corrosion resistant epoxy coatings that can be
applied to dry or damp surfaces. Formulated for broad
range corrosion protection as well as certified safe for
potable water and incidental food contact.
Any surface where corrosion and water resistance is
Potable water structures
Water mains, distribution and transmission lines
Tanks, reservoirs and basins
White is the standard product color. Black, blue, gray, green
and tan are available. Special colors are available on a
limited basis. Contact RLS for more information and
verification of NSF 61 certified colors.
SOLIDS BY VOLUME
100% solids by volume.
Volatile Organic Compounds: 0.0 lbs/gallon
AquataPoxy A-6 is a 100% solids epoxy with zero shrink-
age. Therefore, actual wet film thickness and final dry film
thickness are the same (i.e. 10 mils WFT = 10 mils DFT).
Generally, 8-10 mils (A-6) or 10-80 mils (A-6 Thick)
maximum per coat are recommended to prevent sagging
on vertical or overhead surfaces. Repeat applications may
be necessary to achieve specified coating thickness.
160 sq. ft. per gallon at 10 mils thickness. Actual surface
coverage will depend on surface irregularities. Trials are
recommended to determine the actual coverage required to
yield a desired film thickness for each individual type of
installation. Recommended thickness will vary from
20-150+ mils depending on the installation. Additional
information is available by contacting RLS.
Brush, roller, heated plural component airless or
air-assisted spray. For specific information on application,
spray system design, approved systems and Certified
Applicators contact RLS.
Do not thin with solvents; pinholing and loss of adhesion
can result. Drum heaters and inline heaters on specialized
spray systems can be used to lower viscosity of the epoxy.
Material components should no