http://ccna-exploration-4.blogspot.com/
http://ccna-exploration-4.blogspot.com/
CCNA 2 Module 5 V4.0
1
Refer to the exhibit. The network that is shown is running RIPv1. The
192.168.10.0/24 network was recently added and will only contain end users. What
command or set of commands should be entered on Router1 to prevent RIPv1 updates
from being sent to the end user devices on the new network while still allowing this
new network to be advertised to other routers?
Router1(config-router)# no router rip Router1(config-router)# network 192.168.10.0
Router1(config-router)# no network 192.168.10.0
**Router1(config-router)# passive-interface fastethernet 0/0
Router1(config-router)# passive-interface serial 0/0/0
2
http://ccna-exploration-4.blogspot.com/
http://ccna-exploration-4.blogspot.com/
Refer to the output from the show ip route command. What can be concluded from the
output of this router command?
A preferred route to the destination has not been set.
**There are two equal cost paths to network 1.0.0.0.
Both interfaces are being used equally to route traffic.
A variance must be set to load-balance across multiple paths.
3
Refer to the exhibit. The Ethernet interface on Router2 goes down and the
administrator notices that the route is still in the Router1 routing table. How much
longer will Router1 keep the down network in its routing table before marking it as
possibly down?
30 seconds
90 seconds
**155 seconds
180 seconds
255 seconds
4 What is the default update period in seconds for the RIP routing protocol?
http://ccna-exploration-4.blogspot.com/
http://ccna-exploration-4.blogspot.com/
10
12
15
20
**30
60
5 Which of the following is considered a limitation of RIP v1?
**RIP v1 does not send subnet mask information in its updates.
RIP v1 is not widely supported by networking hardware vendors.
RIP v1 consumes excessive bandwidth by multicasting routing updates using a Class
D add