1. If a router cannot find a valid configuration file during the startup sequence,
what will occur?
The startup sequence will reset.
*The router will prompt the user for a response to enter setup mode.
The startup sequence will halt until a valid configuration file is acquired.
The router will generate a default configuration file based on the last valid
The router will monitor local traffic to determine routing protocol configuration
Refer to the exhibit. The network administrator has configured the router with
the interface IP addresses shown for the directly connected networks. Pings from
the router to hosts on the connected networks or pings between router interfaces
are not working. What is the most likely problem?
The destination networks do not exist.
The IP addresses on the router interfaces must be configured as network
addresses and not host addresses.
* The interfaces must be enabled with the no shutdown command.
Each interface must be configured with the clock rate command.
Refer to the exhibit. What can be concluded from the routing table output in the
exhibit? (Choose two.)
This router only has two interfaces.
The router interfaces are not operational yet.
This router is configured to forward packets to remote networks.
* The FastEthernet0/0 and Serial0/0/0 interfaces of this router were configured
with an IP address and the no shutdown command.
* An IP packet received by this router with a destination address of 198.18.9.1
will be forwarded out of the Serial0/0/0 interface.
Refer to the exhibit. The frame shown in the exhibit was received by the router.
The router interfaces are operational. How will the router process this frame?
The router will change the source and destination IP address in the packet before
forwarding the frame.
* The router will change the frame type to one supported by the WAN link