Service Repair Manual
Models
330F 330F L and 330F LN
Excavator
Shutdown SIS
Previous Screen
Product: EXCAVATOR
Model: 330F EXCAVATOR KFA
Configuration: 330F L & 330F LN Excavators KFA00001-UP (MACHINE) POWERED BY C7.1 Engine
Disassembly and Assembly
C7.1 Engines for Caterpillar Built Machines
Media Number -UENR4468-15
Publication Date -01/06/2015
Date Updated -30/10/2018
i05018640
Rear Power Take-Off (RPTO) - Remove
SMCS - 1165-011-RE
Removal Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A
1P-0520
Driver Group
1
Start By:
a. Remove the flywheel. Refer to Disassembly and Assembly, "Flywheel - Remove" for the
correct procedure.
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
1. If necessary, remove the OEM equipment from the rear power take-off (RPTO).
1/6(W)
w
2020/7/6
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/siswe...
Illustration 1
g02069019
Illustration 2
g02069023
2. Remove bolts (1). Remove adapter (2) from flywheel housing (9). Remove O-ring seal (3)
(not shown).
2/6(W)
w
2020/7/6
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/siswe...
Note: Make a temporary mark on the adapter and the flywheel housing in order to show the
correct orientation of the adapter.
3. Remove bolts (4). Remove adapter (5) from flywheel housing (9). Remove O-ring seal (6)
(not shown).
Note: Make a temporary mark on the adapter and the flywheel housing in order to show the
correct orientation of the adapter.
4. Remove gear (7) from crankshaft (8).
5. If necessary, follow Steps 5.a through Steps 5.b in order to remove the sleeve bearing from
the adapter.
a. Place adapter (2) onto suitable support.
b. Use Tooling (A) and a suitable press in order to remove sleeve bearing (10) from
adapter (2).
6. Repeat Steps 6.a through Step 6.b in order to remove the sleeve bearing from adapter (5).
a. Place adapter (5) onto suitable support.
b. Use Tooling (A)