Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
Exam
: Nortel 920-252
Title
: Ethernet Routing Switch
8600
Version : Demo
Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
1. How do you change an IP address on the Ethernet Routing Switch 8600?
A. use the VLAN Manager
B. delete and recreate the IP address
C. reset the switch, then configure the address again
D. run the ipchange command from the Command Line Interface (CLI)
Answer: B
2. An engineer wants to configure the Virtual Router Redundancy Protocol (VRRP) priority for an IP
interface on a Port-based VLAN. Which Command Line Interface (CLI) command should be used?
A. config ip vrrp <vrid> priority <prio>
B. config vlan <vid> ip vrrp <vrid> priority <prio>
C. config ethernet <vid> ip vrrp <vrid> priority <prio>
D. config ethernet <port> ip vrrp <vrid> priority <prio>
Answer: B
3. Your customer wishes to prevent any IP traffic from being routed to a specific port on their VLAN. What
should you do to accomplish this request?
A. Mask the port in the routing table.
B. Disable RIP on the VLAN segment.
C. Disable routing on the port in question.
D. Remove the port from the neighboring VLAN routing tables.
Answer: C
4. How do you obtain and load an image from an external TFTP server through one of the I/O ports?
A. by configuring the Ethernet Routing Switch 8600 to boot from the network, then reset
B. by invoking the boot (ip address)/<file> command from the Java Device Manager (JDM)
C. by invoking the boot (ip address):<file> command from the Command Line Interface (CLI)
D. by configuring the Ethernet Routing Switch 8600 to boot from the network, then recycle power
Answer: C
Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
5. At which point in a Ethernet Routing Switch 8600 series installation and setup can you initially begin
using the Ja