Simple Guide - Epson Et 2720 Setup
Epson Eco-Tank ET-2720 is an all-in-one and eco-friendly printer having supersized ink tanks. It
is known for its quality photo print and compact design. Before you operate the Epson Et 2720
setup printer, set it up using the following steps.
To Set up Epson ET 2720 printer, Carry out the steps given below.
Take the printer out from the carton and check if all the printer accessories are present.
Peel off the packaging tapes and take off the protective materials from the printer.
2. Filling ink tanks
Keep the ink tank cover open on the printer and open an ink tank.
Take out the ink bottle that corresponds to the ink tank you have opened, from the
Open the ink bottle cap and insert the bottle port into the filling port on the ink tank.
Slowly hold the ink bottle upright and wait until the ink tank is full.
See that you do not pressurize the ink flow by squeezing the bottle.
If the ink flow stops, then remove the bottle from the port and reinsert it.
Once the ink tank is filled, take off the bottle from the filling port and close it with the
Fill the other ink tanks following the same steps and close the Epson Et 2720 setup
printer ink tank cover.
3. Power connection
Connect the power cord provided with the printer between the printer and an electrical
On the printer’s control panel, press the power button to switch on the printer.
After that, set the language of your choice on the display panel.
When the printer system prompts to charge the ink, press the Start button to begin ink
Once the ink charging is complete, a message appears on display.
Now, continue with the printer setup.
4. Feeding paper
Open the paper feeder guard and extend the paper support with a gentle backward push.
Move the edge guides towards opposite ends and place the paper in the rear feed slot such
that the print face is on top.
Make sure that the paper level is not more than the