HammerHead/BombShell Use
Binding Anatomy
The Anti-Ice Tape is used to prevent ice build-up on the tops of the shims.
It is recommended for areas with wet, heavy snow. Replacements are
available.
• Wipe off the tops of the main shim and the HammerHeel body. You can
use a small amount of rubbing alcohol if they are dirty or greasy.
• The Anti-Ice Tape over the two front holes on the shim has a tendency to
break through. If this will bother you, cut 4 pieces of a 3/8" dowel at 1/2"
lengths and drop them into the front holes before you apply the tape.
• Apply the tape and rub out any air bubbles; press hard.
To adjust the binding for your boot size, spin the
adjustment coils in or out of the U-shaped heel tube.
Make sure that both coils have about the same length
showing.
The bindings should be tight enough so that the tail
throw snaps into place when put on your boot (see
tail throw panel). For a stiffer feel put more pre-load
on the main spring by tightening the coils further.
Thank you for choosing TwentyTwo Designs telemark bindings.
Your new bindings will bring your skiing to a new level, enjoy! If you
have any questions or need service please contact us:
info@twentytwodesigns.com
(866) 733-0553 toll free or (208) 354-0553, fax: (208) 354-0554
See www.twentytwodesigns.com/tech for more information.
Warranty
The HammerHead and BombShell bindings, made by TwentyTwo
Designs LLC, are warranted to be free from manufacturing defects for
two years from the date of purchase. If a part fails during this period,
contact us for a replacement at no charge. If a part fails after this
period, contact us for a replacement at a reasonable charge. Normal
wear and tear is not covered under warranty.
-Never apply anything that sprays from a can or contains solvents
to your bindings; it could severely damage the plastic pieces of the
binding. Never use Loctite® when mounting.
Warning
Skiing is an inherently hazardous and dangerous sport. The user of
TwentyTwo Designs LLC products is personally and solely
responsible fo