http://ccna-exploration-4.blogspot.com/
http://ccna-exploration-4.blogspot.com/
CCNA 4 Module 8 V4.0
1. Which two pieces of information are typically found on a logical network diagram?
(Choose two.)
cable types
connector types
• interface identifiers
• DLCI for virtual circuits
operating system versions
2. Excessive broadcasts are generally a symptom of a problem at which layer?
physical
• data link
network
transport
3. What is one example of a physical layer problem?
incorrect encapsulation
incorrect STP configuration
incorrect ARP mapping
• incorrect clock rate
4. Which two components should be taken into consideration when establishing a
network baseline? (Choose two.)
• information about the network design
IP addressing allocation on the network
requirements about the service provider setup
requirements for access control lists to regulate traffic
• expected performance under normal operating conditions
5.
Refer to the exhibit. Which two steps should be taken during the process of creating
network documentation? (Choose two.)
Record the information about the devices discovered in the Campus network only.
• Record the information about the devices discovered in the entire network, including
the remote locations.
• Transfer any information about the devices from the network configuration table that
corresponds to a component of the topology diagram.
Transfer only the Layer 2 and Layer 3 information about the devices from the network
configuration table that corresponds to a component of the topology diagram.
Transfer the recorded information about the devices from the network configuration
table gathered during peak network utilization that corresponds to a component of the
topology diagram.
6. Which two statements are true concerning logical networking models? (Choose
two.)
TCP/IP splits the lowest layer of the OSI model into two separate layers.
• The top layer of the TCP/IP model combines the functions of the top three OSI
layers.
http://ccna-explora