MODEL 30 SHOTGUN
READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS
MANUAL CAREFULLY BEFORE USING THIS FIREARM.
DISCHARGING FIREARMS IN POORLY VENTILATED REAS, CLEANING
FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE
TO LEAD AND OTHER SUSTANCES KNOWN TO THE STATE OF
CALIFORNIA TO CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND
OTHER SERIOUS PHYSICAL INJURY. HAVE ADEQUATE VENTILATION
AT ALL TIMES. WASH YOUR HANDS THOROUGHLY AFTER
TO MAKE GUN SAFE
With hammer cocked, push safety button from left to right until red band is covered
(Note: Safety button is in trigger guard bow). This locks trigger and gun cannot be
fired. Always lock trigger when gun is loaded.
TO RELEASE SAFETY
Push safety button from right to left exposing red band. Gun is ready to fire.
Page 1 of 8
TO LOAD CHAMBER
Open action fully by pulling back the forearm up to rear position. If gun is locked,
press action slide release lever located on rear left side of trigger guard bow. Insert
shell directly into chamber and push forearm forward to close action.
TO LOAD MAGAZINE TUBE
With trigger locked, insert shell upward into bottom of receiver and push forward into
magazine tube past cartridge stops. Repeat until magazine tube is full.
When gun is fired, action automatically unlocks. Forearm can be fully drawn back
and pushed forward. This extracts and ejects fired shell, cocks hammer and carries
new shell into chamber. Gun is now loaded, double locked and ready to fire.
TO REMOVE LOADED SHELL FROM CHAMBER
Put safety button “on” then press action slide release lever by the finger. Slowly
move forearm backward until the shell ejects though ejection port opening facing
TO REMOVE LOADED SHELL FROM MAGAZINE
Turn gun over, trigger guard up, and barrel pointing down. Press cartridge stop left to
release shell from magazine. Remove shell and repeat until magazine is empty.