ccna discovery 3 final v4.0
Note: These answers will give you an 88.2%. numbers 7,16,18,24,26,31,46,51,52,53
are incorrect. Please correct wrong answers. Would like to thank cujoc1111 for this
Refer to the exhibit. A network administrator noticed that the VLAN configuration
changes at SW2 did not propagate to SW3. On the basis of the partial output of the
show vtp status command, what is the possible cause of the problem?
VTP V2 mode is disabled.
SW3 is configured as transparent mode.
The number of existing VLANs does not match.
The configuration revision number does not match.
Refer to the exhibit. Which route will appear in the routing table?
R 10.10.4.0/24 [120/1] via 10.10.10.1, 00:00:12, FastEthernet0/1
R 10.10.4.0/24 [120/1] via 10.10.20.1, 00:00:12, FastEthernet0/0
R 10.10.4.0/24 [120/2] via 10.10.20.1, 00:00:12, FastEthernet0/0
R 10.10.4.0/24 [120/3] via 10.10.30.1, 00:00:12, FastEthernet1/0
R 10.10.4.0/24 [120/1] via 10.10.30.1, 00:00:12, FastEthernet1/0
What will be the two wildcard masks required in an extended access list statement
that blocks traffic to host 192.168.5.45 from the 172.16.240.0/27 network? (Choose
ccna discovery, ccna discovery exam, ccna discovery
course, ccna discovery answers, ccna discovery lab, ccna
discovery v4.0, ccna discovery 1, ccna discovery 2, ccna
discovery 3, ccna discovery 4, ccna discovery curriculum,
ccna discovery chapter 5, ccna discovery chapter 6, ccna
discovery 4.1, ccna discovery chapter, ccna discovery v4