640-822 CCNA Braindump
ExamSoon 640-822 Exams
Cisco Interconnecting Cisco Networking Devices Part 1
O rder : 640-822 Exam
Practice Exam: 640-822
Exam Number/Code: 640-822
Exam Name: Interconnecting Cisco Network ing Devices Part 1
Questions and Answers: 95 Q&As
Free 640-822 Braindumps
Exam : Cisco 640-822
Title : Interconnecting Cisco Networking Devices Part 1
1. Refer to the exhibit. A network technician is attempting to use HyperTerminal to configure a new router using the
settings shown. What is the reason the technician is unable to connect to the router?
A. The bits per second should be set to 9600.
B. The data bits should be set to 6.
C. Parity should be set to mark.
D. The stop bits should be set to 2.
E. Flow control should be set to hardware.
Answer: A
2. An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is turned on and the
switch port link LED turns green. The link light indicates what two conditions? (Choose two.)
A. Layer 2 communication has been established between the PC and switch.
B. The PC has received a DHCP address.
C. Traffic is being sent from the switch to the PC.
D. If flashing, the green LED indicates port speed of 100 Mb/s.
E. The Layer 1 media is functioning between the PC and switch.
F. The switch port is functioning as a half-duplex connection.
Answer: AE
3. Refer to the exhibit. A network administrator has configured a Catalyst 2950 switch for remote management by
pasting into the console the configuration commands that are shown in the exhibit. However, a Telnet session cannot
be successfully established from a remote host. What should be done to fix this problem?
A. Change the first line to interface fastethernet 0/1.
B. Change the first line to interface vlan 0/1.
C. Change the fifth line to ip default-gateway 192.168.17.241.
D. Change the fifth line to ip route 0.0.0.0 0.0.0.0 192.168.17.1.
E. Change the sixth line to line con 0.
Answer: C
4. Refer to the exhibit. The ports that are shown are the only active ports on the swit