CCNA Discovery 4.1 - CCNA Discovery Answers
http://ccna-discovery-4.blogspot.com/
CCNA 4 Chapter 8 V4.0
Labels: CCNA 4 Chapter 8 V4.0
1
Which mechanism is used to create a floating static route?
administrative distance
cost
hop count
passive interface
2
IPSec operates at which layer of the OSI model?
application
network
datalink
transport
3
Which is true regarding Frame Relay LMI?
There are three LMI types standardized by ANSI, ITU-T, and Cisco.
Routers at each end of a Frame Relay virtual circuit must always use the same LMI
type.
The LMI type must be manually configured.
The only function of LMI is to verify the connection between the router and the
Frame
Relay switch.
4
Which statement identifies the IP address design for subinterfaces that
are configured for a Frame Relay network?
Multipoint configurations require the IP address of each subinterface on each router to
be
CCNA Discovery 4.1 - CCNA Discovery Answers
http://ccna-discovery-4.blogspot.com/
in its own subnet.
Multipoint configurations require IP addresses for each subinterface on each router to
be
a part of the same subnet.
Point-to-point configurations require IP addresses for each subinterface on each router
to
be a part of the same subnet.
Point-to-point configurations do not require IP addresses on each subinterface on each
router.
Multipoint configurations do not require IP addresses on each subinterface on each
router.
5
Which three algorithms can be used to encrypt user data in an IPSec VPN framework?
(Choose three.)
3DES
AES
Diffie-Hellman
DES
ESP
SHA
6
Which flag is set by a Frame Relay switch to inform the receiving station that
congestion was experienced?
BECN
DE
FECN
FCS
7
CCNA Discovery 4.1 - CCNA Discovery Answers
http://ccna-discovery-4.blogspot.com/
Refer to the exhibit. The complete configuration of a Frame Relay interface on the
Chicago router
is shown. How does the Chicago router