Page 1 of 2
MATERIAL SAFETY DATA SHEET
MAY BE USED TO COMPLY WITH OSHA'S HAZARD COMMUNICATION STANDARD, 29 CFR 1910.1200 AND SUPERFUND AMENDMENTS
AND REAUTHORIZATION ACT (SARA) OF 1986 PUBLIC LAW 99-499. STANDARD
SHOULD BE CONSULTED FOR SPECIFIC REQUIREMENTS.
SECTION I (IDENTIFICATION)
SUPPLIERS NAME: N94 W14355 Garwin Mace Drive
Menomonee Falls, WI 53051 USA
ALUMINUM FILLER MATERIAL FOR BRAZING OR TIG
SECTION II (HAZARDOUS INGREDIENTS/IDENTITY INFORMATION)
IMPORTANT: This section covers the materials from which these products are manufactured. The fumes and gases produced during normal use of these
products are covered in Section V. The term "Hazardous" in "Hazardous Ingredients" should not only be interpreted as a term required and defined in OSHA
Hazard Communication Standard (29 CFR Part 1910.1200), but also as defined by other regulatory agencies. The chemicals or compounds subject to
reporting under Title III, in Section 313, of the Superfund Amendments and Reauthorization Act (SARA) are marked by the symbol #.
WARNING: This product contains or produces a chemical known to the State of California to cause birth defects (or other reproductive harm) and cancer.
(California Health & Safety Code 25249.5 et seq.)
Exposure Limit (mg/m3)
Percent Ingredients (by Weight)
60 – 100
7 – 13
SECTION III (PHYSICAL DATA) - Wire
SECTION IV (FIRE AND EXPLOSION HAZARD DATA)
Non-Flammable: Welding arc and sparks can ignite combustibles. Refer to American National Standard Z49.1 for fire prevention during welding. These
products as shipped are non-hazardous, n