Service Repair Manual
C18 Industrial Engine
Product: INDUSTRIAL ENGINE
Model: C18 INDUSTRIAL ENGINE WJB
Configuration: C18 Industrial Engine WJB00001-UP
Disassembly and Assembly
C18 Fire Pump Industrial Engine
Media Number -KENR8146-02
Publication Date -01/10/2014
Date Updated -17/10/2014
Flywheel Housing - Remove and Install
SMCS - 1157-010
Tool Part Number Part Description Qty
12 by 12 by 24
a. Remove the crankshaft rear seal. Refer to Disassembly and Assembly, "Crankshaft Rear
Seal - Remove".
b. Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starter
Motor - Remove and Install".
c. Remove the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove
d. Remove the engine speed sensor. Refer to Disassembly and Assembly, "Engine Speed
Sensor - Remove and Install".
Care must be taken to ensure that fluids are contained during
performance of inspection, maintenance, testing, adjusting, and repair
of the product. Be prepared to collect the fluid with suitable containers
before opening any compartment or disassembling any component
Refer to Special Publication, PERJ1017, "Dealer Service Tool
Catalog" for tools and supplies suitable to collect and contain fluids on
Dispose of all fluids according to local regulations and mandates.
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
1. Use Tooling (B) or a suitable block to support the rear of the cylinder block in order to
remove flywheel housing (1). The weight of the engine is approximately 1814 kg (4000 lb).