http://ccna-exploration-4.blogspot.com/
http://ccna-exploration-4.blogspot.com/
CCNA 3 Final 1 V4.0
1
Refer to the exhibit. The Fast Ethernet port Fa0/1 on the switch is configured for auto-
negotiate speed/duplex settings, and the NIC on the machine is set to 100 Mbps, full-
duplex. The log error message shown has been received. What two solutions could fix
the problem? (Choose two.)
Configure the switch manually for auto-negotiate speed/duplex and the NIC on the
machine for 100 Mbps, half-duplex.
**Configure both sides of the link for auto-negotiate speed/duplex settings.
**Manually configure both sides of the link for 100 Mbps, full-duplex.
Manually configure the switch for 100 Mbps, full-duplex, and the NIC on the
machine for auto-negotiate.
Manually configure the switch for 1000 Mbps, full-duplex, and the NIC on the
machine for auto-negotiate.
2
Refer to the exhibit. Both switches are interconnected via a trunk link. Host A and
Host B are on the default VLAN but are not able to exchange traffic. What should be
done to fix the problem?
Allow all VLANs on the trunk link.
**Configure the same native VLAN on both ends of the trunk.
Include a router or switch with Layer 3 capabilities.
Remove the native VLAN from the trunk.
Configure ISL encapsulation on both ends of the trunk.
3
What are two benefits of the IEEE 802.11n standard? (Choose two.)
single-input, single-output
**improved range
requires less equipment
hardware upgrade for compatibility
**increased data rates
4
Refer to the exhibit. Switch SW2 has been newly purchased and added to the network.
What configuration should be applied to SW2 so that it participates in the same VTP
domain as switch SW1, receives VLAN information from SW1, and synchronizes
VLAN information?
Configure SW2 as a VTP server with a higher revision number.
**Configure SW2 as a VTP client.
Configure SW2 in VTP transparent mode.
Configure SW2 with no VTP domain password.
Disable VTP pruning on SW2.
5
Refer to the exhibit. All hosts are