Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
Exam
: CISCO 640-811
Title
:
ICND
Version : Demo
Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
1. Refer to the exhibit. A network technician is troubleshooting a connectivity problem on R2. The technician
enters the show cdp neighbors command at the R2 console. If the network is composed only of Cisco
devices, for which devices should entries be displayed?
A. R1
B. SW-B and R1
C. SW-B, R1, and SW-C
D. R3, SW-B, R1, and SW-C
E. SW-A, R3, SW-B, R1, and SW-C
F. Host A, SW-A, R3, SW-B, R1, and SW-C
Answer: B
2. Refer to the exhibit. What can be determined from the output shown?
A. The JaxSwitch1 switch is using VTP.
B. This is the only switch in the LAN topology.
C. The JaxSwitch1 switch is not the root switch.
D. The link to the root bridge is through a 1 Gbps connection.
E. Spanning Tree Protocol is disabled on the JaxSwitch1 switch.
Answer: C
Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
3. What are the general recommendations regarding the placement of access control lists? (Choose two.)
A. Standard ACLs should be placed as close as possible to the source of traffic to be denied.
B. Extended ACLs should be placed as close as possible to the source of traffic to be denied .
C. Standard ACLs should be placed as close as possible to the destination of traffic to be denied .
D. Extended ACLs should be placed as close as possible to the destination of traffic to be denied .
Answer: BC
4. Refer to the graphic. Which of the following commands would create the output shown at the bottom of
the graphic?
A. Router# show ip eigrp topology
B. Router# show ip route
C. Router# show ip eigrp neighbors
D. Router# show ip ospf route
E. Router# show ip ospf database
Answer: A
5. LAB
Exam1pass
Easiest way to pass IT exams
Exam1pass Help You Pass Any IT Exam
http://www.exam1pass.com
6. Which command is required for connectivity