TECHNICAL DATA SHEET
Emulsion Primer for Self-Adhesive Membranes
-Solids by Volume
8.3 lbs./gal (approx.)
25°F to 104°F
Up to 500 ft2/gal. depending on
porosity and texture of surface.
@ 50% R.H. 68ºF Dry Substrate
Minus 40°F to 150ºF
AquatacTM is a polymer emulsion based primer for self-adhesive membranes.
-Environmentally friendly - Low VOC content.
-Highly tacky film provides positive adhesion to membrane.
-Non-flammable during application.
-Easily applied by spray.
-Water based, no solvent odors.
-Specially designed to provide a high level of tack on vertical surfaces.
Used a primer for self-adhesive membranes such as modifiedPLUS® SA flashing applications, Blueskin® SA and Blueskin® WP 200
when applied to wood, preserved wood, gypsum board including Dens Glass Gold, polystyrene, masonry, concrete and metal.
AquatacTM is the primer of choice when it is necessary to achieve a fast drying, solvent free, tacky surface where walking over the
surface is not required during application. This is important for the application of membranes on vertical surfaces.
Avoid Freezing, store AquatacTM above 32°F. If frozen, allow to thaw at room temperature and mix prior to use. Apply under dry
Surfaces must be dry and free from dust, dirt, grease, oil or other foreign matter.
Aquatac is packaged in 5 gal. Pails.
Henry Company 2911 Slauson Avenue, Huntington Park, CA 90255
Technical Services - Phone: (800) 486-1278 – E-mail: firstname.lastname@example.org
Henry Company is the parent company of Bakor Inc. Monsey Bakor is now Henry Company