READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL
CAREFULLY BEFORE USING THIS FIREARM.
DISCHARGING FIREARMS IN POORLY VENTILATED
FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO
LEAD AND OTHER SUBSTANCES KNOWN TO THE STATE OF CALIFORNIA TO
CAUSE BIRTH DEFECTS, REPRODUCTIVE HARM AND OTHER SERIOUS
PHYSICAL INJURY. HAVE ADEQUATE VENTILATION AT ALL TIMES. WASH
YOUR HANDS THOROUGHLY AFTER EXPOSURE.
INSTRUCTIONS FOR OPERATING AND CARE
This rifle is shipped from the factory with the gunstock packed separately from the
barrel receiver assembly and bolt assembly.
Remove the screw from the stud on the underside of the barrel and directly opposite
the trigger housing. (Note that the stud can be moved sideways and is kept from sliding
out by staking the ends of the dovetail cut). Fit barrel-receiver and trigger housing
assembly to the stock such that the stud freely fits into the hole provided for it in the
gunstock. Tighten screw to nest barrel on the stock.
TO PUT BOLT INTO RECEIVER
Before putting bolt into receiver. Note first if bolt is cocked. If not, push bolt into
receiver as far as possible, then rotate bolt handle upward, thus cocking bolt. With safety
in “F” position and bolt cocked, pull trigger fully, insert bolt into receiver and close fully.
Turn bolt handle downward to lock.
TO LOAD MAGAZINE
Hold magazine firmly in one hand. With the other hand place cartridge on top just
forward of notch and press head downward under ears at rear of magazine. Repeat until
maximum number of cartridges is loaded.
TO MAKE SAFE
Pull safety on right side of receiver in the direction of the “S” mark. This locks
trigger and gun cannot be fired.
TO ATTACH MAGAZINE
Position magazine open end up and ears rearward. Push magazine inward until it
engages with magazine catch.
TO OPEN ACTION
Hold bolt handle and rotate cocking cam counter clockwise. As soon as the lugs clear