JYE Tech - 1 - www.jyetech.com
l Max sample rate - 2M/s，8 bits
l Sample memory depth - 256 bytes
l Analog bandwidth - 1MHz
l Vertical sensitivity - 100mV/Div - 5V/Div
l Vertical position adjustable with indicator
l Input impedance - 1MO
l Max input voltage - 50Vpp
l DC/AC coupling
l Horizontal - 5µs/Div - 10m(minute)/Div
l Auto, normal and single trig modes
l Rising/falling edge trigger
l Trig level adjustable with indicator
l Hold/run feature
l Built-in 500Hz/5Vpp test signal
l Frequency counter features with independent F and T read-outs (only for TTL level input signal)
l 9 - 12V DC or AC power supply
l Dimension: 110mm X 65mm X 25mm (no case)
l Weight: 70 gram (board & probe)
AC/DC Power adapter (universal input voltage range)
1) Do not apply voltage higher than the specified maximum input voltage to
2) Do not attempt to directly measure wall power supply without a
3) Do not use power supply with voltage higher than 12V (DC or rms)
Available from www.dpcav.com
LCD Digital Storage Oscilloscope
JYE Tech - 2 - www.jyetech.com
4. Panel Description
Fig 1 shows the screen and various controls at the front panel. They are explained below.
Y position indicator – shows the 0V position.
Trig level indicator – shows trig level.
3) Window position indicator – reflects the displayed portion of sample memory.
“HOLD” is displayed when the oscilloscope is in HOLD state, which means capturing is halted until
HOLD state is released.
Scope setting indicators – their meaning as shown in Fig. 2.
Power Supply Connector
Locates at bottom