CopyCAD
Erste Schritte
Von Delcam plc
Ausgabe 3.0 30/09/00 09:33
Information contained in this guide is subject to change
without notice and does not represent a commitment by
Delcam plc. The software described in this guide is
furnished under licence agreement and may be used or
copied only in accordance with the terms of such licence.
No part of this guide may be reproduced or transmitted in
any form or by any means, electronic or mechanical,
including photocopying and recording, for any purpose
without the express permission of Delcam plc.
Program 1996 - 2000 Delcam plc
Important Notice
Delcam plc has no control over the use made of the
software described in this guide and cannot accept
responsibility for any loss or damage howsoever caused
as a result of using the software. Users are advised that all
the results from the software should be checked by a
competent person, in accordance with good quality
control procedures.
CopyCAD Erste Schritte
Inhalte • i
Inhalte
Einführung
1
Übersicht .................................................................................. 1
Was zeigt Ihnen diese Lektion? ................................................ 2
Lektion - Leichtmetallfelge
4
Importieren der digitalisierten Punktedaten .............................. 4
Vor dem Anfang............................................................. 6
Ansichten manipulieren............................................................ 8
Säubern der Scandaten.............................................................. 8
Benutzung des Triangulierungsassistenten.............................. 11
Triangulierungsassistenten öffnen ................................ 11
Das triangulierte Modell begrenzen .............................. 17
Löschen der vertikalen Kante ....................................... 21
Modelle löschen ..................................................................... 22
Aufbereitung der Punkte manuell ........................................... 23
Abtastlinien erzeugen ...........................................