Parametric Technology Corporation
CADDS® 5i Composites
CADDS® 5i Release 11
Copyright © 2000 Parametric Technology Corporation. All Rights Reserved.
This document may not be copied, disclosed, transferred, or modified without the prior written consent of
Parametric Technology Corporation (PTC).
Information described in this document is furnished for general information only, is subject to change without
notice, and should not be construed as a warranty or commitment by PTC. PTC assumes no responsibility or
liability for any errors or inaccuracies that may appear in this manual.
The software described in this document is provided under written license only, contains valuable trade secrets
and proprietary information, and is protected by the copyright laws of the United States and other countries.
UNAUTHORIZED USE OF SOFTWARE OR ITS DOCUMENTATION CAN RESULT IN CIVIL DAMAGES AND
Registered Trademarks of Parametric Technology Corporation or a Subsidiary
Advanced Surface Design, CADDS, CADDShade, Computervision, Computervision Services, dVISE,
Electronic Product Definition, EPD, HARNESSDESIGN, Info*Engine, InPart, Optegra,
Parametric Technology Corporation, Pro/ENGINEER, Pro/HELP, Pro/INTRALINK, Pro/MECHANICA,
Pro/TOOLKIT, PT/Products, and Windchill.
Trademarks of Parametric Technology Corporation or a Subsidiary
3DPAINT, Associative Topology Bus, Behavioral Modeler, CDRS, CV, CVact, CVaec, CVdesign, CV-DORS,
CVMAC, CVNC, CVToolmaker, DesignSuite, DIMENSION III, DIVISION, DIVISION EchoCast,
DIVISION MockUp, DIVISION ProductView, DIVISION Reality, dVSAFEWORK, dVS, EDE, e/ENGINEER,
Electrical Design Entry, EPD.Connect, EPD Roles, EPD Visualizer, Expert Machinist, ICEM, ICEM DDN,
ICEM Surf, Import Data Doctor, Information for Innovation, ISSM, MEDEA, MEDUSA, ModelCHECK, NC Builder,
Parametric Technology, Pro/ANIMATE, Pro/ASSEMBLY, Pro/CABLING, Pro/CASTING, Pro/CDT,
Pro/COMPOSITE, Pro/CMM, Pro/CONVERT, Pro/DATA for PDGS, Pro/DESIGNER, Pro/DESKTOP,
Pro/DETAIL, Pro/DIAGRAM, Pro