SETFAST® LOW VOC ACRYLIC
TRAFFIC MARKING PAINT
LEAD FREE YELLOW
• Abrasion resistant
• Bleed resistant
• High visibility
• Glass beads can be added to make reflective markings
• High hiding
• Fast drying
Federal EPA has added acetone to the list of solvents exempt
from the VOC definition. State or local laws may incorporate
the federal definitions, or may use their own, and may take
precedence over the federal rules. Acetone may or may not be
an exempt solvent where state or local regulations are in ef-
fect. Consult with your local Sherwin-Williams representative
for additional information.
White, LF Yellow
VOC (EPA Method 24):
<100 g/L; <0.83 lb/gal
Recommended Spreading Rate per coat:
Approximately 320 lineal feet of standard 4" stripe per gallon
110 sq ft/gal approximate
NOTE: Brush or roll application for small areas only.
If the asphalt is insufficiently cured, applying a thin coat (ap-
proximately 1/2 the recommended dft) generally reduces the
extent of lifting and cracking.
Drying Schedule @ 15.0 mils wet, 50% RH and 77°F:
per ASTM D-711
No traffic pick up after: 5 minutes
Drying time is temperature, humidity and film thickness dependent.
12 months unopened
Store indoors at 40°F to 100°F.
SETFAST LOW VOC ACRYLIC TRAFFIC MARKING PAINT
is a conventional dry (non-heat applied) acetone based paint.
Acetone, as the main solvent, has Exempt Status under Fed-
eral law and does not contribute harmful VOC’s.
This is 100% acrylic, which offers the following outstanding
• Faster dry and hardness development.
• Performance similar to SetFast Chlorinated Rubber Traf-
fic Paint: Less dirt pick-up, longer glass bead ret