Routing and Switching SE/FE
You are configuring a VLAN interface on an internal route processor. You defined the
VLAN interface. What should you do next?
A. define the network number
B. define the default gateway
C. assign IP routing to the interface
D. assign a unique IP address to the interface
Which command associates a map class with an interface or sub interface when
configuring frame relay traffic shaping?
A. frame-relay map
B. frame-relay class
C. map-class frame-relay
D. frame-relay map-class
E. map frame-relay class
You have a Catalyst 5000 switch with a large network. Broadcasts are consuming too
much bandwidth. You want to create VLANs and need inter VLAN communication.
Which hardware accomplishes this?
D. VLAN inters witch
Which device allows communication between VLANs?
A. IP translator
B. route processor
C. switching engine
D. VLAN interswitch
A VLAN, implemented in switching equipment, corresponds to which concept in legacy
A. VTP domain
B. LAN segment
C. routed network
D. ISL trunk interface
Which statements are true above VLANs? (Choose two.)
A. VLANs have connected members located anywhere in the switched network.
B. VLANs improve network segmentation by determining the next network point to
which a frame should be forwarded.
C. VLANs allow a Layer 1 protocoll to determine intelligently the best path to a
destination when multiple paths exist.
D. VLANs solve the scalability problems found in large, flat networks by dividing the
network into smaller broadcast domains or subnets.
Answer: A, D
How many VLANs can s single RSM support?
Which command configures a default gateway on a Catalyst 3500XL switch?
A. Switch(config) ip rou