SERVICE REPAIR
S40FT S50FT S60FT S70FT S55FTS [F187]
1300 SRM 1129
General
General
This section has the repair procedures for the transmission.
SERIAL NUMBER
The transmission serial number is located on the
right side of the transmission control valve directly
below the floor plate. See Figure 1.
A. EARLY LIFT TRUCK MODELS EXCEPT
H4.0FT5/FT6; H4.5FTS5, H4.5FT6; H5.0-5.5FT
(H80, 90, 100, 110, 120FT) (N005, P005)
MODELS
B. NEWER LIFT TRUCK MODELS
Figure 1. Transmission Serial Number
Location
Confidential/Proprietary - Do Not Copy or Duplicate
1
Charge Pump Repair
1300 SRM 1129
Charge Pump Repair
REMOVE
NOTE: The charge pump can be removed from the
transmission while it is still in the lift truck but,
for the sake of clarity, the following procedures are
shown with the transmission removed from the lift
truck.
Remove four mounting capscrews, washers, trans-
mission charge pump, and gasket from the torque
converter housing. Discard the gasket. See Figure 2.
INSPECT
Inspect the splines on the shaft of the transmission
charge pump for damage or worn areas that could
affect the operation of the pump. If the splines are
damaged, replace the transmission charge pump.
INSTALL
Install new gasket, transmission charge pump, four
mounting capscrews, and washers in the torque
converter housing. Tighten capscrews to 19 N•m
(168 lbf in).
NOTE: THE TRANSMISSION IS SHOWN REMOVED
FROM THE LIFT TRUCK FOR CLARITY.
A. EARLY LIFT TRUCK MODELS EXCEPT
H4.0FT5/FT6; H4.5FTS5, H4.5FT6; H5.0-5.5FT
(H80, 90, 100, 110, 120FT) (N005, P005)
MODELS
B. NEWER LIFT TRUCK MODELS
1. CAPSCREW
2. CHARGE PUMP
3. GASKET
4. TORQUE CONVERTER HOUSING
Figure 2. Transmission Charge Pump
2
Confidential/Proprietary - Do Not Copy or Duplicate
1300 SRM 1129
Torque Converter Replace
Torque Converter Replace
REMOVE
WARNING
Make sure the engine and transmission are
held in position so that they will not fall and
cause an injury and damage to the equipment.
CAUTION
Be careful that you do not damage