Analysis User's Manual
Volume I: Introduction, Spatial Modeling, Execution & Output
Analysis User's Manualsion
Printed on: Tue August 5 – 15:26:55 2003
The information in this document is subject to change without notice and should not be construed as a commitment by ABAQUS, Inc.
ABAQUS, Inc., assumes no responsibility for any errors that may appear in this document.
The software described in this document is furnished under license and may be used or copied only in accordance with the terms of such license.
No part of this document may be reproduced in any form or distributed in any way without prior written agreement with ABAQUS, Inc.
©ABAQUS, Inc., 2003.
Printed in U.S.A.
All Rights Reserved.
ABAQUS is a registered trademark of ABAQUS, Inc. The following are trademarks of ABAQUS, Inc.: ABAQUS/Aqua; ABAQUS/CAE; ABAQUS/Design;
ABAQUS/Explicit; ABAQUS/Foundation; ABAQUS/Standard; ABAQUS/Viewer; ABAQUS Interface for MOLDFLOW; ABAQUS Interface for MSC.ADAMS;
and the ABAQUS, Inc., logo.
This release of ABAQUS may contain capabilities licensed under U.S. Patents 5,920,491 and 6,044,210. ABAQUS, Inc., may also have other patents or
pending patent applications, trademarks, copyrights, or other intellectual property rights covering subject matter in this document. The furnishing of this
document does not give you any license to the patents, trademarks, copyrights, or other intellectual property rights except as expressly provided in any
written license agreement from ABAQUS, Inc.
ADAMS/Flex, ADAMS/View, MSC.ADAMS, and MSC.Patran are trademarks or registered trademarks of MSC.Software Corporation or its subsidiaries in the
United States and/or other countries.
Autodesk Inventor is a trademark and Autodesk Mechanical Desktop is a registered trademark of Autodesk Inc.
CADKEY is a registered trademark of CADKEY Corporation.
CATIA is a registered trademark of Dassault Systémes.
Compaq Alpha is registered in the U.S. Patent and Trademark Office.