M16 R / M1600 R
READ THE INSTRUCTIONS AND SAFETY PRECAUTIONS IN THIS MANUAL
CAREFULLY BEFORE USING THIS FIREARM.
DISCHARGING FIREARMS IN POOLY VENTILATED AREAS, CLEANING
FIREARMS OR HANDLING AMMUNITION MAY RESULT IN EXPOSURE TO
LEAD AND OTHER SUSBSTANCES KNOWN TO THE STATE OF CALIFORNIA
TO CAUSE BIRTH DEFECT, REPRODUCTIVE HARM AND OTHER SERIOUS
PHYSICAL INJURY. HAVE ADEQUATE VENTILATED AT ALL TIMES. WASH
YOUR HANDS THOROUGHLY AFTER EXPOSURE.
This rifle is shipped from the factory fully assembled and ready to shoot. Clean the rifle
from excessive oil and grease before using.
TO LOAD MAGAZINE: Hold the magazine box firmly with one hand and, with the
other, place a cartridge into the magazine throat just in front of the supporting notch.
Push the cartridge head down and rearward until it is securely locked in place. A
maximum of fifteen rounds may be loaded.
TO ATTACH MAGAZINE: Push the magazine into the trigger guard housing opening,
until the magazine locks in place.
TO DETACH MAGAZINE: Push magazine release forward until the magazine catch
releases the magazine. Pull the magazine away from the trigger guard.
Page 1 of 9
TO MAKE GUN SAFE: Safety lever is at the right side of the receiver and at the back
of the bolt operating handle. Pull safety latch toward the “S” mark on the receiver. This
locks trigger and gun cannot be fired.
TO LOAD CHAMBER: With the safety on, insert a loaded magazine into the rifle. Pull
the bolt operating handle all the way to the rear and release, allowing the bolt to move
forward under full force of the operating springs. Bolt automatically picks up a cartridge
from the magazine and feeds it into the chamber. Do not ease bolt forward.
TO FIRE: Be sure gun is pointed at safe target. Release safety and pull the trigger.
Pressure from the burning powder opens up bolt, ejects empty shell, and reloads the
chamber for the next shot. Pull the trigger again. Gun fires