Workshop manual
101 89 83-26
362XP/365/371XP
CONTENTS
Introduction ................................................. 1
Safety regulations ....................................... 2
Symbols ....................................................... 3
Technical data.............................................. 4
Service tools ................................................ 6
Trouble shooting ......................................... 8
Service information ................................... 10
Safety equipment ...................................... 12
Recoil starter ............................................. 16
Electrical system ....................................... 18
Centrifugal clutch ...................................... 22
Lubrication system ................................... 24
Carburettor................................................. 26
Tank unit..................................................... 35
Anti-vibration system................................ 37
Piston and cylinder ................................... 38
Crankcase and crankshaft........................ 42
0 Eng Innehåll
98-09-25, 17.45
1
INTRODUCTION
English – 1
This workshop manual can be used in two different ways:
• Repair of a specific sub-assembly on the chainsaw.
• Dismantling and reassembly of the whole chainsaw.
Warning markings are shown both in this manual and on the
chainsaw itself. See page 5. If a warning mark on the
chainsaw has been damaged or is missing, it must be
replaced immediately in order to maximise safety when the
saw is in use.
General
This manual provides a detailed description of procedures
for trouble shooting, repair and testing of the chainsaw. The
safety precautions that should be taken during repair work
are also described.
Safety
Always use Husqvarna original:
• Spares
• Service tools
• Accessories
For specific procedures special tools are required. In this
workshop manual, all the service tools required are listed.
Their use is described in the appropriate section.
Tools
The manual should be read and unders