TM 5-3800-205-23-2
0008 00-1
BACKUP ALARM REPLACEMENT
0008 00
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Unit
Tools and Special Tools
Tool kit, general mechanic’s (Item 33, WP 0048 00)
Materials/Parts
Strap, tiedown (Item 38, WP 0047 00)
Equipment Condition
Machine parked on hard, level surface (TM 5-3800-
205-10-1)
Scraper bowl lowered to ground (TM 5-3800-205-
10-1)
Parking brake applied (TM 5-3800-205-10-1)
Wheels chocked (TM 5-3800-205-10-1)
Battery disconnect switch in OFF position (TM 5-
3800-205-10-1)
NOTE
Backup alarm is located on crossmember, underneath rear deck. Alarm can be accessed from underneath
machine.
REMOVAL
1.
Remove electrical tiedown strap (3) and discard.
2.
Disconnect backup alarm connector (2) from wiring harness connector (1).
1
2
3
390-1753
TM 5-3800-205-23-2
0008 00-2
BACKUP ALARM REPLACEMENT - CONTINUED
0008 00
REMOVAL - CONTINUED
3.
Remove two screws (4), washers (5), and backup alarm (6) from crossmember (7).
INSTALLATION
1.
Install backup alarm (6) on crossmember (7) with two washers (5) and screws (4).
2.
Connect backup alarm connector (2) to harness connector (1).
3.
Install new tiedown strap (3).
END OF WORK PACKAGE
4,5
6
7
390-1754
1
2
3
390-1753
TM 5-3800-205-23-2
0009 00-1
REAR HUB AND DISC REPLACEMENT
0009 00
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Unit
Tools and Special Tools
Tool kit, general mechanic’s (Item 33, WP 0048 00)
Shop equipment, common no. 1 (Item 24, WP 0048
00)
Link, bracket (Item 4, WP 0048 00)
Sling, nylon (Item 27, WP 0048 00)
Personnel Required
Two
Materials/Parts
Grease, GAA (Item 16, WP 0047 00)
Rag, wiping (Item 31, WP 0047 00)
Gasket
Equipment Condition
Brake caliper removed (WP 0011 00)
REMOVAL
1.
Remove six bolts (1) and cover (2) from hub (3).
2.
Remove and discard gasket (4) from cover (2).
1
2
3
4
2
390-551
390-552
TM 5-3800-205-23-2
0009 00-2
REAR HUB AND DISC REPLACEMENT - CONTINUED
0009 00
REMOVAL - CONTINUED
3.
Remove locknut (5) from axle shaft (6).
4.
Remove tab loc