SERVICE REPAIR
H13.00XL H14.00XL H16.00XL Europe [C019]
1
THE FRAME
GENERAL
This section has the description and repair procedures
for the frame and connected parts. Included in this sec-
tion are the frame, counterweight, fenders, hood, hy-
draulic and fuel tanks, radiator, operator compartment
and cab. The instructions for removal and installation of
the engine are included in this section.
DESCRIPTION
The frame is a one piece weldment and has mounts for
the counterweight, fenders, overhead guard, engine,
transmission, axles, hydraulic and fuel tanks, operator’s
compartment, and other parts.
COUNTERWEIGHT
WARNING
The counterweight is heavy. Make sure that the
crane and lifting devices have the capacity to lift
4600 kg (10143 lb).
Removal (See FIGURE 2.)
1. Remove the hood assembly.
2. H8.00–9.00XL (H165–210XL) units only. Remove
the cover (3) and bracket (5) from the counterweight.
3. Install lift chains through the radiator grill in the coun-
terweight and attach the chains to a lifting device.
H13.00–16.00XL (H300–360XL) units. Remove the
radiator hardware. Tilt the radiator away from the
counterweight so that there is clearance when the chains
are installed through the counterweight.
4. Remove the single capscrew from the rear of the
counterweight. Raise the counterweight approximately
300 mm (12 inches). Remove the counterweight from
the frame. There can be shims between the counter-
weight and the counterweight mounts on the frame. Fas-
ten the shims to the frame with tape so they can be used
when the counterweight is installed.
Installation
WARNING
The counterweight is very heavy. Make sure that the
crane and lifting devices have the capacity to lift
4600 kg (10143 lb).
1. Put a chain through the opening in the counterweight
and attach the chains to a lifting device.
1. MAIN FRAME MEMBER
2. MOUNT, CAB SUPPORT
3. COUNTERWEIGHT MOUNT
4. STABILIZER BAR, ON
H8.00–12.00XL (H165–280XL) ONLY
5. MOUNT, STEERING AXLE
6. MOUNT, DRIVE AXLE
7. MOUNT,