Student Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Lesson 3: Surface Creation
In this lesson, you will learn how to create surfaces from wireframes.
Lesson 3: Surface Creation
Lesson content:
Case Study: Surface Creation
Design Intent
Stages in the Process
Choice of Surface
Sweeping a Profile
Create a Multi-Section Surfaces
Create a Adaptive Sweep Surface
Student Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Case Study: Surface Creation
Case Study: Surface Creation
The case study for this lesson is the “Car Door substrate with Arm rest”. The focus of this case study is the
creation of Surfaces from a given wireframe data to check the Design feasibility. Your goal is to achieve
the editable model of “Car Door substrate with Arm rest”. which incorporates the design intent of the part.
The focus of the case study in this lesson is to understand, how to access Surface Design workbench and
to manage a few basic tools.
Student Notes:
V5 Surfaces
Copyright DASSAULT SYSTEMES
Copyright DASSAULT SYSTEMES
Design Intent (1/2)
Create a Door Substrate. The substrate profile needs to be
adaptable for design modification & changes without replacing
the original input .
Create an Adaptive Sweep
Create a broad cross-section surface for an ‘Arm rest’
attached to the front door for design feasibility study.
Create a profile sweep with single guide curve option.
Create a cross-section surface for ‘Key-pad’ (for
Electronic control ) at a measured distance from the Arm rest
ankle point.
Create a profile sweep from a given sketch with single guide
curve.
Attain a single merged part by using Arm rest and the key
pad component.
Create a Multi-section surface between two different profiles
of Armrest and Key-pad to form an integrated single part.
Close the end of the Arm rest & Key-pad with rounded end.
Use the revolve option to attain the rounded ends.
The intent is to create surfaces for design fea