Cisco-Training.net
1
A network administrator has been told that the company IP address
infrastructure must adhere to RFC 1918. What three IP address ranges from
RFC 1918 could the administrator use on the network? (Choose three.)
• 10.0.0.0/8
127.0.0.0/8
169.254.0.0/16
• 172.16.0.0/12
• 192.168.0.0/16
209.165.201.0/27
2
Refer to the exhibit. Routers East and West are configured using RIPv1. Both
Cisco-Training.net
routers are sending updates about their directly connected routes. The East
router can ping the West router serial interface and West can ping the serial
interface of East. However, neither router has dynamically learned routes from
the other. What is most likely the problem?
A gateway of last resort is required.
Subnetting is not supported by RIPv1.
• VLSM is not supported by RIPv1.
One of the routers needs a clock rate on the serial interface.
3
Refer to the exhibit. What effect will the commands that are shown have on RIP
updates for Router1?
Only version 2 updates are sent to 255.255.255.255.
• Only version 2 updates are sent to 224.0.0.9.
Both version 1 and version 2 updates are sent to 224.0.0.9.
Both version 1 and version 2 updates are sent to 255.255.255.255.
4
Cisco-Training.net
Refer to the exhibit. What can be concluded from the output shown in the
exhibit?
The routing table is limited to 2 routes.
The LAN interfaces are participating in the routing process.
One update has been sent out of each serial interface and 2 have been received.
Cisco-Training.net
• The no auto-summary has not been configured on this router.
5
What are two reasons to implement RIP version 2 rather than RIP version 1?
(Choose two.)
• RIP version 2 supports VLSM.
RIP version 2 supports more than 16 routers.
RIP version 2 supports classful (and not classless) routing
• RIP version 2 supports routing update authentication.
RIP version 2 supports multi-areas.