SERVICE REPAIR
S135XL S155XL S155XL2 [C024]
100 SRM 449
Description
General
This section has the description and repair procedures for the frame and connected parts. Included in this sec-
tion are the frame, counterweight, hood, hydraulic and fuel tanks, radiator, and exhaust system. Also included
are the instructions for removal and installation of the engine.
Description
The frame is a one-piece weldment and has mounts for the counterweight, upright, overhead guard, engine
and transmission, axles, and other parts. See Figure 1.
1. HOOD
2. FLOOR PLATE
3. OVERHEAD GUARD
4. COUNTERWEIGHT
5. FRAME
Figure 1. Frame and Connected Parts
1
Counterweight Repair
100 SRM 449
Counterweight Repair
REMOVE
WARNING
The lift truck must be put on blocks for some
types of maintenance and repair.
The re-
moval of the following assemblies causes large
changes in the center of gravity: upright,
drive axle, engine and transmission, and the
counterweight. When the lift truck is put on
blocks, put additional blocks in the following
positions to maintain stability:
a. Before removing the upright and drive axle,
put blocks under the counterweight so that
the lift truck cannot fall backward.
b. Before removing the counterweight, put
blocks under the upright assembly so that
the lift truck cannot fall forward.
The surface must be solid, even, and level when
the lift truck is put on blocks. Make sure that
any blocks used to support the lift truck are
solid, one piece units.
Do not operate the lift truck if the capscrews
for the counterweight are not installed. When
the capscrew is removed, the counterweight
can fall from the lift truck.
WARNING
Make sure any lifting devices have the correct
capacity for the parts being moved. See Fig-
ure 2.
1.
If the lift truck has an LPG fuel system, remove
the LPG tank and bracket so that the counter-
weight can be removed. See Figure 2.
WARNING
LPG can cause an explosion. Do not cause
sparks or permit flammable material near the
L