Cosa C'è di Nuovo in
CopyCAD 6.0
Di Delcam plc
Versione 25/11/04
Disclaimer
Delcam plc has no control over the use made of the software described in
this manual and cannot accept responsibility for any loss or damage
howsoever caused as a result of using the software. Users are advised that
all the results from the software should be checked by a competent
person, in accordance with good quality control procedures.
Information contained in this manual is subject to change without notice
and does not represent a commitment by Delcam plc. The software
described in this manual is furnished under licence agreement and may be
used or copied in accordance with the terms of such licence. No part of
this manual may be reproduced or transmitted in any form or by any
means, electronic or mechanical, including photocopying and recording,
for any purpose without the express permission of Delcam plc.
Copyright © 2004 Delcam plc. All rights reserved.
Delcam plc
Talbot Way
Small Heath Business Park
Birmingham B10 OHJ
England
Tel:
(UK) 0121-766-5544
(Int) +44 (0) 121-766-5544
What's New in CopyCAD 6.0
Contenuti • i
Contenuti
Introduzione
1
Premessa...........................................................................................1
Nuove Funzioni
7
Piani di lavoro ..................................................................................7
Menu Piani di Lavoro ............................................................8
Menu Oggetto Piano di Lavoro ...........................................10
Miglioramenti della Modellazione di Triangoli ............................11
Crea Primitive Triangolo .....................................................12
Booleana su Triangoli..........................................................18
Esempio di Booleana su Triangoli ......................................21
Miglioramenti della Modifica Triangoli Interattiva ............26
Morphing di Triangoli....................................................................27
Morphing di Triangoli Esempio ..........................