Instructor Notes:
CATIA V5 Fundamentals - Lesson 2: Profile Creation
Copyright DASSAULT SYSTEMES
2-1
Copyright DASSAULT SYSTEMES
Lesson 2: Profile Creation
In this lesson you will learn how to create a simple part.
Lesson content:
Case Study: Profile Creation
Design Intent
Stages in the Process
Create a New Part
Select Appropriate Sketch Support
Create Sketched Geometry
Constrain the Sketch
Create Pad Feature
Saving and Closing Documents
Duration: Approximately 0.33 day
Lesson Content
Student Guide: Lesson 2: Profile Creation
Introduce the lesson. Present the lesson objectives and topics.
The document is for study only,if any tort to your rights,Please inform us,we will delete it
www.cadfamily.com
Contact:cadserv21@hotmail.com
Instructor Notes:
CATIA V5 Fundamentals - Lesson 2: Profile Creation
Copyright DASSAULT SYSTEMES
2-2
Copyright DASSAULT SYSTEMES
Case Study: Profile Creation
The case study for this lesson is the support plaque used in the drill support assembly and
shown below. The support plaque is part of the Drill Support sub-assembly. The focus of this
case study is the creation of a profile that incorporates the design intent for the part.
Case Study: Profile Creation
Student Guide: Lesson 2-Case Study: Profile Creation
Introduce the case study for this lesson.
The support plaque is part of the drill support sub-assembly.
Locate where the support plaque is in the sub-assembly and where the sub-assembly is
in the main assembly.
It may be helpful to open a session of CATIA and locate the support plaque inside the
assembly.
The document is for study only,if any tort to your rights,Please inform us,we will delete it
www.cadfamily.com
Contact:cadserv21@hotmail.com
Instructor Notes:
CATIA V5 Fundamentals - Lesson 2: Profile Creation
Copyright DASSAULT SYSTEMES
2-3
Copyright DASSAULT SYSTEMES
Design Intent
The model must be created in one
feature.
The smaller holes must be 30mm away
from the center hole.
The center hole must remain in the
ce