Service Repair Manual
Model
232D Skid Steer Loader
Shutdown SIS
Previous Screen
Product: SKID STEER LOADER
Model: 232D SKID STEER LOADER KXC
Configuration: 232D Skid Steer Loader KXC00001-UP (MACHINE) POWERED BY C2.2 Engine
Disassembly and Assembly
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines
Media Number -KENR6948-06
Publication Date -01/06/2015
Date Updated -02/08/2018
i06720081
Flywheel - Remove
SMCS - 1156-011
Removal Procedure
Table 1
Required Tools
Tool Part Number
Part Description
Qty
A
138-7573
Link Bracket
1
B
-
Guide Stud
(M10 x 1.25 mm by 80mm)
2
Start By:
a. Remove the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting
Motor - Remove and Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
Note: The three cylinder and the four cylinder engines have different flywheels. The removal
procedure is similar for all models.
1/3
232D Skid Steer Loader KXC00001-UP (MACHINE) POWERED BY C2.2 Engine(S...
2019/10/3
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sis...
Illustration 1
g01305297
Typical example
1. Install Tooling (A) and a suitable lifting device to flywheel (2). The weight of the flywheel
is approximately 42 kg (93 lb).
2. Remove two bolts (1) from positions (X) on the flywheel.
3. Install Tooling (B) in positions (X) on the flywheel.
4. Remove the remaining bolts (1) and remove flywheel (2).
Note: On some three cylinder engines, a roll pin is located between the crankshaft and the
flywheel.
5. Inspect ring gear (3) and flywheel (2) for wear or damage. If the ring gear or the flywheel is
worn or damaged, use new parts for replacement.
2/3
232D Skid Steer Loader KXC00001-UP (MACHINE) POWERED BY C2.2 Engine(S...
2019/10/3
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sis...
Illustration 2
g00825639
Typical example
6. To remove ring gear (3) from flywheel (2), place the flywheel on a suitable support. Use a
h