Exclusive to Durkan Commercial, Mohawk Commercial Carpet,
Bigelow Commercial, and Durkan Patterned Carpet.
Mohawk Group Modular Systems
and Durkan Patterned Carpet Tile
500 TownPark Lane Suite 400
Kennesaw, GA 30144
Field Technical Services Department
405 Virgil Drive
Dalton, GA 30721
MG809 SLT0000911 1/0655448 Modular System-E 12/30/05 8:47 AM Page 1
Mohawk Modular Systems and Durkan Patterned Carpet Tile
Mohawk Modular Systems and Durkan Patterned Carpet Tile are intended for installation on dry,
properly prepared floors. These products are not intended for installation on walls, outside use, or
The Mohawk Group or Durkan Patterned Carpet is not responsible for any product failure if
proper floor preparation and or installation procedures are not followed. The required adhesive is
NuSpraylok™. For those applications where trowel able adhesives are desired, use NuBroadlok™
pressure sensitive. It is the responsibility of the installation contractor to make
certain the floor is properly prepared and suitable for the installation of The Mohawk Modular
Systems or Durkan Patterned Carpet Tile.
Excessive moisture and high pH (alkalinity) in the floor can cause a product failure. When using
pressure sensitive releasable tile adhesive the moisture emission from the floor should not exceed
3.0 pounds per 1,000 square feet in 24 hours. The acceptable pH range is 7.0 to 9.0 lbs. When
using NuSprayLok™ the moisture should not exceed 7 lbs per 1,000 square feet in 24 hours. The
acceptable pH range is 11.0 lbs. If moisture is high a primer should not be applied.
Site and Material Condition
The floor should have a minimum temperature of 65ºF for at least 72 hours prior to installation and
48 hours after installation. Temperatures should not exceed 90ºF. Relative humidity above 65%
will adversely affect the adhesive and primers.
Installation of Mohawk Modular Systems or Durkan Pa