AWD110 Rev. 1 (12/05)
Copyright© 2005, Alpha Communications®, All Rights Reserved
AlphaStatus™ system Master Station
Labelling/Numbering Instructions to
be used with the Labelling Software
or with customer provided number tabs
42 Central Drive, Farmingdale NY 11735-1202
(631) 777-5500 Fax: (631) 777-5599
TOLL-FREE Technical Line 1-800-666-4800
Labelling of Master Switch/Buttons can be done either before the module is put into the
frame or after. However, we recommend that they be marked during installation or re-
moved from the frame for labelling. Be careful not to pinch, crimp or break wiring when
removing / installing the module(s).
Working from the LEFT side of the unit, with a small screwdriver or a coin, gently push
up on the ridge at the top of the lens at the point shown below.
Each AlphaStatus™ system is provided with a CD-Rom contain-
ing software to easily create and maintain your Master Station
labelling/ numbering. If the CD is lost or misplaced you can down-
load this software free from our website at:
www.alpha-comm.com, in the DOWNLOADS section.
Once the lens is separated from the button assembly, place the label that you have made
with the included software, or handwritten on a blank label, on the LEFTMOST side, so
as not to obscure any of the indicator LEDs. When satisfactorily aligned, gently replace
the lens with the raised bell button to the RIGHT.
Do not exert excessive pressure on the switch to seat the lens, as it will attach easily.