Thank you for purchasing my Xbox 360 dual rapid fire kit, that will give you endless fun at beating you
friends at some games such as Call Of Duty 4 , Halo 3 and many others of which require you to press the
trigger buttons very fast.
You will need to have soldering abilities and wire stripping abilities
This will work for both controller types shown below
In the non likely event of it not working or damaging your controller we will not be held liable for
damaging your controller
You do this at your own risk.
Computerpaulb’s Xbox 360 dual rapid fire kit
You Will Need
A Security Torx T8 you can use a regular T8
Torx but you have to get a knife and break
the pins in the middle / Small Phillips
screwdriver for wired controllers
Wire Strippers and Cutters
Soldering Iron and solder
Glue Gun plus Sticks
1.5mm drill bit or 5/32 drill bit
You Have Got
80 cm of wire
2 buttons
2 1k ohm resistors
Pre-programmed chip
Step one – Opening the controller
1. Remove the 7 security screws with your T8 Torx security screwdriver. Or Phillips if wired
2. Whilst keeping the controller upside down remove the back of the controller shell.
3. Take the board out of the other half of the shell and place the front half of the shell to
One side.
4. Place the controller board right side up like below
1. Cut the wire into 6 pieces. You will need (3) pieces 5.5cm long, (2) pieces 6.5cm
Long and (1) piece 11.5cm long. After cutting the wire you will need to strip the ends
Of them off.
2. Cut 2 of the legs off of the buttons. Refer to pictures and this step is only for the kits
Including 4 pin buttons. Remove two pins from the same side.
3. Cut the pins down on the chip. This will make it easier to reassemble your controller
When you are finished.
4. Pre-Solder the wire. This will help you do a cleaner install and reduce the risk of burning
Your chip and intern frying your controller.
Step two – Prep the parts
Step three – Glue do