CCNAAnswers.com
CCNA 3 Chapter 4 V4.0 Answers
1. Which statement is true when VTP is configured on a switched network that
incorporates VLANs?
VTP is only compatible with the 802.1Q standard.
VTP adds to the complexity of managing a switched network.
VTP allows a switch to be configured to belong to more than one VTP domain.
VTP dynamically communicates VLAN changes to all switches in the same VTP
domain.
2.
Refer to the exhibit. What information can be learned from the output provided?
It verifies the configured VTP password.
It verifies the VTP domain is configured to use VTP version 2.
It verifies VTP advertisements are being exchanged.
It verifies the VTP domain name is V1.
Read more…
CCNAAnswers.com
CCNA 3 Chapter 3 V4.0 Answers
1.
Refer to the exhibit. The network administrator has just added VLAN 50 to Switch1 and
Switch2 and assigned hosts on the IP addresses of the VLAN in the 10.1.50.0/24 subnet
range. Computer A can communicate with computer B, but not with computer C or
computer D. What is the most likely cause of this problem?
There is a native VLAN mismatch.
The link between Switch1 and Switch2 is up but not trunked.
The router is not properly configured for inter-VLAN routing.
VLAN 50 is not allowed to entering the trunk between Switch1 and Switch2.
2.
CCNAAnswers.com
Refer to the exhibit. The exhibited configurations do not allow the switches to form a
trunk. What is the most likely cause of this problem?
Cisco switches only support the ISL trunking protocol.
The trunk cannot be negotiated with both ends set to auto.
By default, Switch1 will only allow VLAN 5 across the link.
A common native VLAN should have been configured on the switches.
Read more…
CCNA 3 Chapter 2 V4.0 Answers
CCNAAnswers.com
1. If a network administrator enters these commands on a switch, what will be the result?
Switch1(config-line)# line console 0
Switch1(config-line)# password cisco
Switch1(config-line)# login
to secure the console port with the password "cisco"
to