Exam : Cisco 640-802
Title
: Cisco Certified
Network Associate
(CCNA)
Version : Demo
Cheat-Test,help you pass any IT exam!
Cheat-Test.com All rights reserved
1. Refer to the exhibit. What could be possible causes for the "Serial0/0 is down" interface status?
(Choose two.)
A. A Layer 1 problem exists.
B. The bandwidth is set too low.
C. A protocol mismatch exists.
D. An incorrect cable is being used.
E. There is an incorrect IP address on the Serial 0/0 interface.
Answer: A, D
2. The network administrator has discovered that the power supply has failed on a switch in the
company LAN and that the switch has stopped functioning. It has been replaced with a Cisco
Catalyst 2950 series switch. What must be done to ensure that this new switch becomes the root
bridge on the network?
A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.
Answer: A
3. Refer to the exhibit. Assume that all of the router interfaces are operational and configured correctly.
How will router R2 be affected by the configuration of R1 that is shown in the exhibit?
Cheat-Test.com All rights reserved
A. Router R2 will not form a neighbor relationship with R1.
B. Router R2 will obtain a full routing table, including a default route, from R1.
C. R2 will obtain OSPF updates from R1, but will not obtain a default route from R1.
D. R2 will not have a route for the directly connected serial network, but all other directly
connected networks will be present, as well as the two Ethernet networks connected to R1.
Answer: A
4. Before installing a new, upgraded version of the IOS, what should be checked on the router, and
which command should be used to gather this information? (Choose