AWD002 Rev. 3 (08/01)
Copyright© 1994-2001, Alpha Communications®, All Rights Reserved
MODEL CP202SS COVER PLATE
For use with the OR202 Duo-Com™ Remote
IMPORTANT INFORMATION AND RESTRICTIONS:
The CP202SS cover plate can only be used on our model OR202 remote station.
It may be possible to use the CP202SS with another manufacturer's remote station. However,
any such use is strictly at the customer's risk. Any modifications made to the CP202SS to fit
another manufacturer's remote station is at the customer's risk, and voids all warranties either
express or implied.
INSTALLATION GUIDELINES and GENERAL INFORMATION:
Remove any tape holding the "CALL" button in place. Make sure that there is no sticky residue on the
back of the "CALL" button before installing the OR202 inside.
Place one of the large washers supplied onto each mounting post inside the CP202SS cover plate.
These washers must be installed before the OR202 remote is placed inside the CP202SS unit.
Install the OR202 remote inside of the CP202SS, making sure that the "CALL" button is installed into
the CP202SS properly.
Use the two (2) hexagonal nuts provided to secure the OR202 remote to the mounting posts inside the
CP202SS cover plate. NO NOT OVER-TIGHTEN the nuts, as this could cause damage to the OR202
remote station. Make sure the "CALL" button operates easily and without jamming.
Screw the entire assembly to the finished wall using the four (4) 'STAR' security screws provided, or
by using screws of your own choice.
*NOTE: The CP202SS is not
provided with a ' STAR' head
screwdriver tip. This can be
ordered separately, using our
CONVERT YOUR OR202 REMOTE TO A VANDAL-RESISTANT
REMOTE BY ADDING OUR CP202SS COVER PLATE
42 Central Drive, Farmingdale NY 11735-1202
(631) 777-5500 Fax: (631) 777-5599
TOLL-FREE Tech Support 1-800-666-4800