MATERIAL SAFETY DATA SHEET
Crystal Foam Kill
Date Prepared: 01/01/2009
Crystal Foam Kill
CTI (Chemical Technologies International Inc.)
3765 Omec Circle #2
Rancho Cordova, CA 95742
Phone: (916) 638-1315 Fax: (916) 638-0712
Emergency Assistance Calls: Chemtrec (800) 424-9300 (U.S.A.) 24hrs.
This product has not been tested as a whole for health effects on animals or humans. According to the OSHA
Communications Standard (29 CFR 1910.1200) any hazardous ingredients that comprise >1.0% of the material and
any carcinogenic ingredients that comprise >0.1% must be listed on the MSDS. When individually tested at 100%
ingredients in the make-up of this product posed the following health hazards.
SECTION II a: HAZARDOUS INGREDIENTS >1.0%
SECTION II b: CARCINOGENIC INGREDIENTS AT >0.1%
(SEE SECTION 8 FOR EXPOSURE GUIDELINES)
EYES: May cause eye irritation.
SKIN: None expected.
INHALATION: None expected.
INGESTION: May cause abdominal discomfort, nausea and diarrhea.
EYES: Flush with water for at least 15 minutes. If irritation persists consult physician.
INGESTION: Drink 1 to 2 glasses of water. Consult physician.
INHALED: Remove to fresh air. If symptoms persist or are severe seek prompt medical assistance.
SKIN: Remove contaminated clothing. Thoroughly wash exposed area with soap and water.
PHYSICIAN: Treatment based on judgment of attending physician.
FLASH POINT: N/A
AUTO-IGNITION TEMPERATURE: N/D
EXPLOSIVE LIMITS - UEL: N/D LEL: N/D
EXTINGUISHING MEDIA: Alcohol foam, water fog, CO2 or dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Use NIOSH/MSHA approved self-contained positive pressure breathing
apparatus and protective clothing where this material is involved in a fire.
UNUSUAL FIRE AND EXPLOSION HAZARD: None known.
MSDS Product: Crystal Foam Kill
Page1of 3, Revised Date: 01-01-2009
SECTION 1 – MATERIAL AND MANUFACTURER IDENTIFICATION
SECTION 2 – COMPOSITION / INFORMATION ON INGREDIENTS
SECTION 3 – Hazards Identification