21
5. ASSEMBLY AND DISASSEMBLY
5-1. TOOLS FOR DISASSEMBLY AND ASSEMBLY
NO.
TOOL
1
Box driver
10mm
13mm
19mm
Motor (1), Balance (5), 2 holes of each left and right of the
shock absorber 1 Pulley hole
2
Double-ended
spanner
10, 13,19mm
Replaceable for the box driver.
Since the bolt runs idle when the box driver is used, use the
box driver 17mm.
3
Vice pliers
Tool to protect the idle and abrasion of the bolt for the
box driver.
4
Other(Driver, Nipper, Long nose)
General tools for the after service.
5
JIG for the Tub
1 (Disassemble and Assemble)
CLICK HERE TO DOWNLOAD THE COMPLETE MANUAL
• Thank you very much for reading the
preview of the manual.
• You can download the complete
manual from: www.heydownloads.com
by clicking the link below
• Please note: If there is no response to
CLICKING the link, please download
this PDF first and then click on it.
CLICK HERE TO DOWNLOAD THE COMPLETE MANUAL
22
Part Name
Descriptive Picture
How To Do
ASS’Y-
COVER TOP
ķ Remove the two screws holding the
Top Cover at the back of the unit.
ĸRemove the top-cover through push
ing and pulling.
Ĺ Then, the Water (Pressure) Sensor,
Noise Filter and Water Valve can be
replaced.
5-2. ASSEMBLY AND DISASSEMBLY
Warning! To avoid risk of electrical shock, personal injury or death, disconnect the power to the washing
machine
sensor pressure
water valve
noise fi lter
23
Part Name
Descriptive Picture
How To Do
FRAME
FRONT
ķ Remove the Top Cover and the Ass’y
Drawer.
ĸ Remove the two screws on the front of the
control panel.
Ĺ Remove the two screws on the plate(u).
ĺRemove the control panel by disconnect
ing the connector that connects PCB to
the wire-harness.
24
Part Name
Descript ive Pic ture
HowTo Do
FRAME
FRONT
¤º Insert a flat head screwdriver into the gap and
pry down the Cover Front (Left) to separate it.
¤ Remove the Wire Diaphragm from the Frame
Front and unseat the Diaphragm.
¤ Remove the 7 screws on the frame front.
25
Part Name
Descriptive Picture
How To