Service Repair Manual
Models
320, 320L TRACK-TYPE
EXCAVATOR
Shutdown SIS
Previous Screen
Product: EXCAVATOR
Model: 320 L EXCAVATOR 1KL
Configuration: 320, 320L TRACK-TYPE EXCAVATORS 1KL00001-UP (MACHINE) POWERED BY 3066 ENGINE
Disassembly and Assembly
3064 and 3066 Engines for Caterpillar Built Machines
Media Number -SENR5553-10
Publication Date -01/05/2012
Date Updated -15/05/2012
i01615246
Inlet and Exhaust Valves - Remove and Install
SMCS - 1105-010
Removal Procedure
Table 1
Required Tools
Tool
Part Number
Part Description
Qty
A
8S-6691
Cylinder Head Repair Stand
1
B
1P-3527
Valve Spring Compressor
1
C
5S-1322
Valve Keeper Installer
1
D
8S-2263
Spring Tester
1
Start By:
A. Remove the cylinder head. Refer to Disassembly and Assembly, "Cylinder Head -
Remove".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened component life.
1/5(W)
w
2019/12/27
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sis...
Illustration 1
g00610449
Illustration 2
g00610469
1. Support cylinder head assembly (1) on Tool (A) .
2. Use tool (B) to compress valve spring (2) .
3. Use the magnetic end of tool (C) (not shown) to remove cap (4) and valve keepers (3).
Slowly release the pressure on tool (B) and remove tool (B) .
4. Remove retainer (5) and remove spring (2) .
2/5(W)
w
2019/12/27
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sisweb/sis...
Illustration 3
g00525271
5. Check the valve spring force with Tool (D). Refer to Specifications, "Valve Mechanism" for
information on the valve springs.
6. Remove exhaust valve (6) and inlet valve (7) through the bottom of the cylinder head
assembly (1). Put identification marks on the valves for installation purposes.
7. Perform the following procedure, if the valves need to be refaced:
a. Set the machine that will reface the valves at an angle of 30 degrees.
b. The valve has a stellite facing. This facing will be gone, if the margin o