Service Repair Manual
Models
340F Excavator
Shutdown SIS
Previous Screen
Product: EXCAVATOR
Model: 340F EXCAVATOR RBD
Configuration: 340F Excavator RBD00001-UP (MACHINE) POWERED BY C9.3 Engine
Disassembly and Assembly
C9.3 Engines for Caterpillar Built Machines
Media Number -UENR0130-06
Publication Date -01/08/2015
Date Updated -22/05/2017
i03897450
Fuel Lines - Remove and Install
SMCS - 1274-010
Removal Procedure
Contact with high pressure fuel may cause fluid penetration and burn
hazards. High pressure fuel spray may cause a fire hazard. Failure to
follow these inspection, maintenance and service instructions may cause
personal injury or death.
NOTICE
Contact with high pressure fuel may cause personal injury or death.
Wait 60 seconds after the engine has stopped to allow fuel pressure to
purge before any service or repair is performed on the engine fuel
lines.
NOTICE
Care must be taken to ensure that fluids are contained during
performance of inspection, maintenance, testing, adjusting and repair
of the product. Be prepared to collect the fluid with suitable containers
1/7
340F Excavator RBD00001-UP (MACHINE) POWERED BY C9.3 Engine(M007667...
2020/12/9
https://127.0.0.1/sisweb/sisweb/techdoc/techdoc_print_page.jsp?returnurl=/sis...
before opening any compartment or disassembling any component
containing fluids.
Dispose of all fluids according to local regulations and mandates.
NOTICE
Cleanliness is an important factor. Clean the exterior of the engine
before the removal procedure. Ensure the area around the Fuel
Manifold and the Fuel Lines are thoroughly cleaned. This action will
prevent contaminants from entering the internal mechanism. Before
replacing any Fuel Lines, follow the instructions that are listed below.
Replace the Fuel Lines with the correct Fuel Lines Group.
Note: The following procedures were written for the complete removal of all of the fuel lines and
clamps. If only specific fuel lines need to be replaced then only remove the fuel lines and clamps
that need replacem