CCNA 2 Module 1 V4.0
1. If a router cannot find a valid configuration file during the startup sequence, what
The startup sequence will reset.
*The router will prompt the user for a response to enter setup mode.
The startup sequence will halt until a valid configuration file is acquired.
The router will generate a default configuration file based on the last valid
The router will monitor local traffic to determine routing protocol configuration
Refer to the exhibit. The network administrator has configured the router with the
interface IP addresses shown for the directly connected networks. Pings from the
router to hosts on the connected networks or pings between router interfaces are not
working. What is the most likely problem?
The destination networks do not exist.
The IP addresses on the router interfaces must be configured as network addresses
and not host addresses.
* The interfaces must be enabled with the no shutdown command.
Each interface must be configured with the clock rate command.
Refer to the exhibit. What can be concluded from the routing table output in the
exhibit? (Choose two.)
This router only has two interfaces.
The router interfaces are not operational yet.
This router is configured to forward packets to remote networks.
* The FastEthernet0/0 and Serial0/0/0 interfaces of this router were configured with
an IP address and the no shutdown command.
* An IP packet received by this router with a destination address of 198.18.9.1 will be
forwarded out of the Serial0/0/0 interface.
Refer to the exhibit. The frame shown in the exhibit was received by the router. The
router interfaces are operational. How will the router process this frame? (Choose
The router will change the source and