Exam
: Alcatel-Lucent 4A0-110
Title
: Alcatel-Lucent Advanced
Troubleshooting
Version : Demo
1. Two routers are physically connected to each other over Ethernet port 1/1/1. Review the configuration
information shown below. What state should the OSPF neighbor be in?
A. INIT
B. EXCHANGE
C. EXSTART
D. FULL
E. No OSPF neighbor
Answer: E
2. Which of the following debug statements can be used to troubleshoot if the OSPF adjacency is staying at
xstart state? Select two answers.
A. debug router ospf rtm
B. debug router ospf packet dbdescr
C. debug router ospf neighbor
D. debug router ospf packet hello
E. debug router ospf spf
Answer: BC
3. Based on the following configuration, which of the following statements are true? Choose all that apply.
A. No OPSF adjacency found on Node 1
B. Full OSPF adjacency between Node-1 and Node-2
C. Full OSPF adjacency between Node-1 and Node-3
D. Full OSPF adjacency between Node-1 and Node-4
E. OSPF is enabled on Node 1
Answer: BE
4. Two routers are physically connected to each other over Ethernet port 1/1/1. Review the configuration
information below. What state should the OSPF neighbor be in?
A. INIT
B. EXCHANGE
C. EXSTART
D. FULL
E. No OSPF neighbor
Answer: D
5. Two routers are physically connected running ISIS. ISIS L2 adjacency is up and running but L1
adjacency is not up. Review the configuration information shown below:
Which of the following statement best describe the cause of the problem? Select one answer only.
A. The ISIS interface level is not configured on both routers
B. The ISIS interface type should be configured as point-to-point interfaces
C. ISIS System IDs are not configured on both routers
D. ISIS Area addresses are not configured on both routers
E. ISIS level capacity are not configured on both routers
Answer: D
6. Two routers are physically connected to each other with ISIS configured. No ISIS adjacency can be
found on both routers. Ping works fine on the local and the remote interface addresses on both routers.
Review the confguration information shown below.
Which