BCM50 Rls. 3.0, BCM200/400 Rls. 4.0 &
BCM450 Rls. 1.0 Installation,
Configuration & Maintenance
You have installed a DSM32+ MBM in slot 1 of a new BCM450 main unit and you want to
connect a set and perform set-based programming. What is the next step?
A. Identify the module.
B. Deconfigure the module.
C. Configure the module.
D. Connect a set to the DSM32+.
Click on the Exhibit button.
While configuring a DTM module on a BCM450, the module was mistakenly identified as
a DTM- PRI instead of a DTM-T1.What must you do to correct the module identification?
A. Select the row of the DTM you configured. Click the Configure button and enter DTM-
T1 as the module type.
B. Select the row of the DTM you configured. Click the Deconfigure button. Click OK.
Double-click the Configured Device column and select DTM-T1 as the module type.
C. Select the row of the DTM you configured. Double-click the onfigured Device column
and select DTM-T1 as the module type.
D. Select the row of the DTM you configured. Click the Disable button. Click OK. Double-
click the Configured Device column and select DTM-T1 as the module type.
Which Media Bay Module (MBM) can be combined with the G4x16 on the same DS30 bus
on a BCM200/400 system?
D. BRI S/T
You need to renumber a group of DNs. You also want to move the voice mailboxes with the
renumbered DNs. Which BCM system allows you to do this?
A. BCM50 Rls. 2.0
B. BCM50 Rls. 3.0
C. BCM400 Rls. 4.0
D. BCM450 Rls. 1.0
Click the Exhibit button.
You are configuring IP trunks on a new BCM450 that does not have a Capacity Expansion
Card (CEC). The authorization license allows you to have 32 VoIP trunks. For the company
planned future growth, 40 IP trunks on the system are set in the configuration so the total
number of lines i