SERVICE MANUAL
DUMPER
10TFT, 9TFT, 9TST
EN - 9813/5350 - ISSUE 2 - 01/2018
This manual contains original instructions, verified by
the manufacturer (or their authorized representative).
Copyright 2018 © JCB SERVICE
All rights reserved. No part of this publication may
be reproduced, stored in a retrieval system, or
transmitted in any form or by any other means,
electronic, mechanical, photocopying or otherwise,
without prior permission from JCB SERVICE.
www.jcb.com
Foreword
The Operator's Manual
You and others can be killed or seriously injured
if you operate or maintain the machine without
first studying the Operator's Manual. You must
understand and follow the instructions in the
Operator's Manual. If you do not understand
anything, ask your employer or JCB dealer to
explain it.
Do not operate the machine without an Operator's
Manual, or if there is anything on the machine you
do not understand.
Treat the Operator's Manual as part of the machine.
Keep it clean and in good condition. Replace the
Operator's Manual immediately if it is lost, damaged
or becomes unreadable.
Contents
01 - Machine
06 - Body and Framework
09 - Operator Station
15 - Engine
18 - Fuel and Exhaust System
21 - Cooling System
24 - Brake System
25 - Steering System
27 - Driveline
30 - Hydraulic System
33 - Electrical System
72 - Fasteners and Fixings
75 - Consumable Products
78 - After Sales
18 - Fuel and Exhaust System
96 - Fuel Pipe
03 - High Pressure Pipe
18 - 79
9813/5350-2
18 - 79
03 - High Pressure Pipe
Remove and Install
Special Tools
Description
Part No.
Qty.
Socket 17MM Offset -
(HP Fuel pipes)
331/27987
1
Torque Wrench
(10-100Nm)
993/70111
1
Important. Before disconnecting or removing fuel
pipes proceed as follows.
1. Make sure that you have the correct new parts.
1.1. The high pressure fuel pipes MUST BE
REPLACED with new ones.
1.2. The new fuel pipes must remain sealed
inside their bags before use. If a bag is open
DO NOT USE the fuel pipe, get a new one.
2. Obey all
fuel system health and safety
information. Refer to (PIL 18-0