Simple Guide - Epson ET 2600 Setup
Epson ET 2600 is an All-in-One printer that can print, copy, and scan. This printer also
supports wireless printing, and so you can quickly connect any wireless device with this
printer. If you are doing the Epson ET 2600 setup for the first time, follow these steps.
Unpack your printer first and then take out the supplies such as CD-ROM, power
cord, user guide, and ink bottles.
Remove the protective tapes from the printer and make sure to recycle them.
Open the ink tank cover and remove the cap for the black ink first.
Unpack the black ink bottle from the cover and open the bottle cap.
Load the black ink bottle into the black tank’s filling port of Epson ET 2600 setup.
Do not force ink filling by squeezing the bottle.
Repeat the same steps to fill other ink tanks.
Once you have completed loading the ink tank, close the cover and secure the
empty ink bottles.
Connect the printer to an electrical outlet using the supplied power cord.
Raise the printer’s control panel and press the Power button.
Next, press and hold down the Stop button for at least three seconds to begin ink
Once the process is completed, open the paper feed slot and slide the edge
Fan a stack of paper and load it into the paper feed slot.
Adjust the loaded paper by sliding the paper width guide.
Next, pull out the paper output tray and raise the paper stopper.
Install the Epson ET 2600 driver on your computer using the supplied CD-ROM.
After completing the driver installation, verify the Epson ET 2600 setup printer
Epson Et 2600 Wireless Setup:
Make sure you have a standard USB cable handy.
Place your printer and computer closer to the router to reduce Wi-Fi interference.
Turn on the Epson ET 2600 setup printer, computer, and router.
Connect your computer to the router using the wireless settings.
Verify that you have completed the basic printer settings to proceed Epson ET
2600 wireless setup